Description
Yamaha TF rack – Spécifications
| TF-RACK | ||
|---|---|---|
| Outline | ||
| Mixing Capacity | Input Channels | 40 (32 mono + 2 stereo + 2 return) |
| Aux Buses | 20 (8 mono + 6 stereo) | |
| Stereo Buses | 1 | |
| Sub Buses | 1 | |
| Input channel functions | 8 DCA Groups | |
| I/O | Inputs | 16 mic/line (XLR/TRS combo) + 1 stereo line (RCA pin) |
| Outputs | 16 (8 XLR + 8 TRS phone) | |
| Expansion slots | 1 (for NY64-D) | |
| On-board processors | DSP | 8 Effects + 10 GEQ |
| General specifications | ||
| Sampling frequency rate | Internal | 48 kHz |
| Signal delay | Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz | |
| Fader | Resolution = 10-bit, +10 dB to –138 dB, –∞ dB all faders | |
| Total harmonic distortion | Less than 0.05% 20 Hz–20 kHz @+4 dBu into 600 Ω, INPUT to OMNI OUT, Input Gain=Min. (Measured with a –18 dB/octave filter@80 kHz) | |
| Frequency response | +0.5, –1.5 dB 20 Hz–20 kHz, refer to +4 dBu output @1kHz, INPUT to OMNI OUT | |
| Dynamic range | 110 dB typ., DA Converter, 108 dB typ., INPUT to OMNI OUT, Input Gain=Min. | |
| Hum & noise level | Equivalent input noise | –128 dBu typ., Input Gain=Max. (Measured with an A-Weight filter) |
| Residual output noise | –85 dBu, ST master off (Measured with an A-Weight filter) | |
| Crosstalk | –100 dB (Measured with a –30 dB/octave filter@22 kHz), adjacent INPUT/OMNI OUT channels, Input Gain=Min. | |
| Power requirements | 100–240 V 50/60 Hz | |
| Power consumption | 85 W | |
| Dimensions | W | 480 mm (18-7/8 in) |
| H | 132 mm (5-1/4 in) | |
| D | 409 mm (16-1/8 in) | |
| Net weight | 9.2 kg (20.3lb) | |
| Accessories | Quick Guide, Power Cord NUENDO LIVE (DAW Software), Rubber stoppers(4) | |
| Options | Audio Interface Card (NY-64D), Foot Switch (FC5) | |
| Others | Operating temperature range: 0–40 °C, Storage temperature range: -20–60 °C | |
Recording/ Playback
| PC/Mac (USB2.0) | Recording 34 tracks, Playback 34 tracks |
| USB Storage Device | Recording 2 tracks (USB hard drive/ SSD)*, Playback 2 tracks (USB hard drive/ SSD/ thumb drive) |
*Please note – USB thumb drives are not supported by TF for recording purposes. Please refer to this link for compatible hard drives.
Analog input characteristics
| Input Terminals | GAIN | Load Impedance |
For Use With Nominal |
Input Level | Connector | balanced / Unbalanced |
||
|---|---|---|---|---|---|---|---|---|
| Sensitivity*1 | Nominal | Max. before clip | ||||||
| INPUT1-16 | +66dB | 7.5KΩ | 50-600Ω Mics or 600Ω Lines |
-82dBu (61.6μV) | -62dBu (0.616mV) | -42dBu (6.16mV) | Combo Jack (XLR-3-31 type *2 or TRS phone *3) |
Balanced |
| -6dB | -10dBu (245mV) | +10dBu (2.45V) | +30dBu (24.5V) | |||||
| ST IN | — | 10kΩ | 600Ω Lines | -30dBV (31.6μV) | -10dBV (316mV) | +10dBV (3.16V) | RCA Pin Jack | Unbalanced |
*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*4. In these specifications, 0dBu = 0.775Vrms.
*5. +48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.
Analog output characteristics
| Output Terminals | Source Impedance |
For Use With Nominal |
Output Level | Connector | balanced / Unbalanced |
|
|---|---|---|---|---|---|---|
| Nominal | Max. before clip | |||||
| OMNI OUT 1-8 | 75Ω | 600Ω Lines | +4dBu (1.23 V) | +24dBu (12.3 V) | XLR-3-32 type *1 | Balanced |
| OMNI OUT 9-16 | TRS Phone Jack *6 | |||||
| PHONES *5 | 100Ω | 40Ω Phones | 3mW | 75mW | Stereo Phone Jack (TRS) *2 | Unbalanced |
*1. 1: GND, 2: HOT, 3: COLD
*2. Tip: LEFT, Ring: RIGHT, Sleeve: GND
*3. In these specifications, 0dBu = 0.775Vrms.
*4. All output DA converters are 24bit, 128times oversampling.
*5. The position of the level control is lowered by 16dB from the maximum.
*6. Tip: HOT, Ring: COLD, Sleeve: GND
Digital input/output specifications
| Terminals | Format | Data length | Audio | Connector |
|---|---|---|---|---|
| USB (TO HOST) | USB | 24bit | 34ch input / 34ch output, PCM | USB (B type) |
| iPad | USB | — | Playback: MP3 or WAV file data / Record: WAV file data | USB (A type) |
Control I/O specifications
| Terminals | Format | Level | Connector |
|---|---|---|---|
| NETWORK | IEEE802.3 | 10BASE-T/100Base-TX | RJ-45 |
| FOOT SW | — | — | TS Phone |
Autres références chez Yamaha
Surface de contrôle
- 72 pistes avec la CL5
- 64 canaux avec la CL3
- 48 pistes avec la CL1
- 64 pistes avec la QL5
- 32 canaux avec la QL1
Mixette
Stage box et interfaces
- Rack de 8 entrées avec réseau Dante : RI8B
- Boitier de scène 16 pistes avec réseau dante : Rio 1608D
- Boitier de scène 32 pistes avec réseau dante : Rio 3224 D
- Convertir Dante et Madi : RMio64-D I/O Rack
- Rack de 8 sorties ligne en XLR, entrées Dante, 1U : Ro8-D
- Interface audio pour convertir le Dante et les cartes Mini-YGDAI , 64 inputs and 64 outputs : RSio64-D
- Boitier de scène économique 16 pistes avec réseau dante : Tio 1608
Options
- Vue mètre console : MBCL
- Alimentation de secours 220 volts
- Les cartes interfaces
Voir aussi
- Autres accessoires pour la lumière
- Le câblage informatique pour la communication
- Modulation pour la scène / boitier
- Les microphones
- DJe rack format 19 pouces avec patch réseau et plus encore
- Flightcase innovant sur mesure pour console avec Dje case
- Machinerie / le berceau
